3D Motorcycle Tank Pad Protector – Epoxy Resin Decal

Your Tank Deserves More Than Just Paint

Every time you lean forward on your bike, your knees and jacket press against that fuel tank. Over time, scratches and scuffs are inevitable — unless you protect it. This 3D motorcycle tank pad protector shields your tank from daily wear while adding a sharp, race-inspired look that turns heads at every stop.

Protection That Looks as Good as It Works

• 🛡️ 3D epoxy resin construction — raised, glossy finish that absorbs impact and resists scratches
• 🏎️ Carbon fiber & racing designs — 7 bold styles to match your bike’s personality
• 🔒 Anti-slip protection — keeps your grip steady and your tank surface safe
• 🌧️ Waterproof & weatherproof — built to handle rain, heat, and road grime
• ✂️ Machine-cut precision fit — clean edges, professional finish
• 🔧 Self-adhesive backing — simple peel-and-stick install, no tools needed

Install in Minutes, Protect for Years

The self-adhesive backing makes installation effortless. Clean your tank surface, peel the backing, position the tank pad protector, and press firmly. Use a card to smooth out any air bubbles, then peel the transfer film slowly. That’s it — your tank is protected and looking sharper than ever.

How to Apply

1. Clean the tank surface thoroughly and ensure it is completely dry and grease-free.
2. Peel the paper backing carefully, keeping the pad on the transfer tape.
3. Position the pad on the tank and press firmly from the center outward.
4. Use a card or squeegee to smooth out any air bubbles.
5. Slowly peel away the transfer film at a low angle — the pad stays in place.
6. For best results, apply in a warm environment and press firmly after installation.

Specifications

• Material: Epoxy resin / PVC
• Finish: 3D raised, carbon fiber look
• Special features: Anti-slip, waterproof, reflective
• Available designs: 7 variants
• Installation: Self-adhesive, no tools required

Only a few units left in select designs — upgrade your tank before they’re gone.