There are two installation methods for this product:

 1. Double-sided adhesive is provided. Please clean the sticking position before pasting, and then paste it directly.

 2.The bracket clip seat is an optional accessory. Tighten the screws and clip it on the handrail. When installing, the solar panel of the product should face the bright position, and it can continuously charge the product.

3. Open the waterproof rubber plug on the back of the product, and use a thin object such as a pen or a toothpick to push the sliding switch inside the product upwards to turn on the power.

 4. This product uses touch buttons and can be operated by touching with your fingers. When operating, only operate one button at a time and then operate another button. Do not press two buttons simultaneously. The button positions are on the side below the display screen, as shown in the following figure:

 The time setting operation is as follows:

△Press the      or  ▽ button to switch between °C and °F.

Press the  ○  button for 3 seconds to enter the time setting mode, and then press the  ○button again to enter the setting sequence: hour → minute → year → month → date → confirmation.

○
In the setting mode, press the up or down button to adjust the numbers up or down. Press the     button to switch between the 12/24 hour modes.

In a dark environment, when the vehicle is driving, the backlight automatically turns on. In the daytime or in a strong light environment, the backlight automatically turns off. When the product freezes, please push the switch on the back of the product to turn it off, and then turn it on again after a few seconds.